Skip to content

Dana Dolly V3 Beltless — Physical Install

Source: eMotimo Support

This article covers mounting the DDV3 Beltless motor unit to the Dana Dolly carriage. The primary reference is the eMotimo install video — the steps below summarize the key points.

Install Video

Watch the eMotimo install video at the source article (Instagram embed). The first 30 seconds of the video shows the motor mounted with the Conductor SA2.6 — the physical mounting is the same for Spectrum ST4 setups.

Key Point: Engaging the Motor

After mounting, the drive wheel must be engaged before it will make contact with the speed rail:

  • Pull the silver locking pin — this releases the motor from its locked (disengaged) position
  • The drive wheel will drop down and make firm contact with the track

See Engaging and Disengaging the Motor for full details.

Next Steps

After physical install:

  1. Update firmware on your Spectrum ST4 or Conductor SA2.6
  2. Install the sensor board and marker stickers: